This set of legs is a stand for your K&M Rock Crusher. Set includes 4 legs, 4 cross member brackets and all the nuts, bolts, and washers needed. These legs will fit all of the K&M Krushers. This set has been designed to fit the 11" Crusher and the 14" Crusher with the the cross members having 4 holes in the center so with either size machine will have 2 holes line up for the 2 nuts & bolts (provided). All 4 legs & brackets are identical so assembly is a "no brainer." This set of legs will raise your crusher 21.25" off the floor. The legs are 24" tall and slide into your crusher frame. Holes have been cut in the bottom plate so you can either bolt it to the cement floor, or put locking casters on them. The hole pattern is center to center 2.75" X 1.75" laser cut slightly oblong. This pattern fits most all of the 3-5" casters on the market. Assembly is simple: Support the crusher up about 24" and slide in the 4 legs all the way, then sit the crusher down. Next, put the cross member supports together to lock in the legs. The brackets end with one hole attaches to the leg. Either side works as all 4 legs have holes on both sides. (We suggest the holes on the outer sides of the legs). Now pull the 2 brackets up together to meet in the middle of the legs and insert 2 nuts & bolts. Repeat this on the other side and then tighten up all the nuts to the bolts and you are ready to go. (After the first set up no need to remove the brackets from the legs as they fit inside for storage). This rock crusher stand is made in the USA! Approximate weight is 45 pounds. Shipping box dimensions: 28 x 16 x 10 inches.
NOTE: These legs will fit all of the K&M brand rock crushers sold on this site and might work on other machines from jaw crushers to other manufacturers' crushers. The legs at the insertion spot or top is 2-5/8" tall and 1-5/8" wide. Its designed to fit a frame that measures 2"x3" rounded steel tubing.