Skip to main content
#
 
cart
our twitterour facebook page pintrest youtube
Latest Posts
Archive
Categories

 Nuggets of News Blog 

Wednesday, June 14 2017

Fun and exercise are two great reasons to go gold prospecting, but you might as well make some money while you're at it, right? The best way to do that is to increase production rates. Assuming you are mining on a known gold-bearing claim or waterway, volume is the key to your success!

gold panningGraduating from the basic gold pan to some other form of simple equipment is the best way to increase production rates. Just going from a pan to a sluice will increase production by at least 500%, depending on how it is used. A highbanker will work about the same amount of material as a well-run sluice, though it can move the water to you instead of you bringing the gravel to the water, thereby dramatically incsuction dredgereasing volume of production. A drywasher will produce similar results by allowing you to work without water.

A dredge or highbanker/suction dredge combo is the next step up. A dredge uses a gas motor to generate the suction that will load and transport the material to the sluice, which greatly increases volume, as well as allows you to reach gravel on the river bottom that would otherwise be inaccessible (unless the river is seasonal or there is a prolonged drought). The more material a dredger can push across the riffles, the more gold can be recovered. An additional benefit to dredging is that it also allows you to clean gold out of all the cracks and crevices in the bedrock. A shovel just cannot do that.

The size of the dredge intake nozzle is the most important factor in how much material a dredge can process, but it is not a direct one-to-one relationship. For example, a 5 inch dredge will not move twice the material that a 2.5 inch dredge can move. It actually can move much more. The surface of the hose is figured in square dredge nozzleinches, the area (and therefore the volume) goes up much faster than the diameter and the corresponding production rates go up proportionally. A larger hose size will also clog less because more sizes of rock and gravel will pass through. Having to stop and remove clogs can significantly reduce the time you get to spend actually moving dirt and finding gold. No matter the size, you're likely to have rocks jam up the hose from time to time, but generally, the larger the hose the less frequent the clogs that slow or stop production. In most areas of the country, a 2 inch dredge is considered a "recreational" size and may not require a permit to use, whereas much larger nozzle sizes would require a permit. Always know the laws where you intend to gold prospect and mine before you buy equipment.

Beyond dredges or highbanker/suction dredge combos, you can get into some professional mining set-ups that use trommels and jigs and shaker tables and earth moving equipment. Every deposit is different, varying in size and grade and structure. Environmental conditions and access will dictate mining methods and knowing the rock types and size of the gravel is critical in determining which equipment will work best for increasing your production. Finding a suitable deposit to mine and finding a way to work it economically— to justify your time and expense— is the first step.  Then choose the right equipment to increase your recovery rate and speed of recovery and make more money.  Good luck!

Posted by: Denise AT 04:00 pm   |  Permalink   |  Email
Facebook
Pinterest
Twitter
Add to favorites

Nugget of News Blog